安装 BCM4310 USB 无线网卡

摘自:http://linux.dell.com/wiki/index.php/Tech/Wireless/Truemobile_ndiswrapper 

Ubuntu 8.04 也适用

Configuration/installation of ndiswrapper under Ubuntu 7.04


NOTE:' More general information about ndiswrapper on Ubuntu can be found [here].
1. ndiswrapper installation

From a command line, run the following command:

sudo apt-get install ndiswrapper-common ndisgtk

2. Disable the "bcm43xx" driver on your system

Run the following command at a command prompt:

echo 'blacklist bcm43xx' | sudo tee -a /etc/modprobe.d/blacklist

3. Download the Windows driver for your card

Go to support.dell.com and download the appropriate Windows driver for your TrueMobile card (should be something like R123456.EXE). Save this in the /tmp directory
cd into the /tmp directory, and unzip the Windows driver package

cd /tmp
unzip http://ftp.us.dell.com/network/R174291.exe
(or whatever the name of the download is)

4. Install the Windows driver with ndiswrapper

Run the following command to load the driver

sudo ndiswrapper -i /tmp/DRIVER/bcmwl5.inf

Verify that the driver has been loaded

ndiswrapper -l

The output of this command should look like the following if it is loaded correctly

Installed ndis drivers:
{name of driver} driver present, hardware present

or

{name of driver} : driver installed
device ({Chipset ID}) present

5. Load the ndiswrapper module

You now need to load the ndiswrapper module. Complete the following steps at a command prompt:

sudo depmod -a
sudo modprobe ndiswrapper

You may also want to check for error messages:

tail /var/log/messages

Assuming there are no errors, you should then try to bring up the network connection.
6. Configure network manager to use your wireless card

1. Open the Networking Admin tool (System | Administration | Networking), select the Wireless connection and click Properties, ensure the Enable roaming mode checkbox is ticked.
2. Click the Network Manager icon (computers icon in the top right corner of system tray), your network ESSID should be shown in the drop-down list. Select your network by clicking on it.
3. If the Network requires any further configuration (eg WEP key), a dialog should appear, select the correct settings and paste in your key.

7. Set the ndiswrapper module to automatically load at boot

If you are using the network manager applet to configure Wireless Network, ndiswrapper will not be started by the network manager alias setting. You must configure your system to load the ndiswrapper module at system startup. To do this, edit /etc/modules file to add an entry for ndiswrapper at the end of the file.

gksudo gedit /etc/modules

then add the word ndiswrapper to the end of this file and save it.

Your wireless should now work on subsequent reboots.

发表评论

电子邮件地址不会被公开。 必填项已用*标注

此站点使用Akismet来减少垃圾评论。了解我们如何处理您的评论数据